OSCIDRUM

[kEllZ]

"/Volumes/EasyUploader/EasyUploader.app/Contents/MacOS//avrdude" -c arduino -p m328p -C "/Volumes/EasyUploader/EasyUploader.app/Contents/MacOS/avrdude.conf" -P /dev/cu.usbserial-A906XJIY -U flash:w:"/Users/kellyraymondrobertbrown/Downloads/AteOscidrumV1-0Factory.hex":i
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x00

avrdude done.  Thank you.

[paulsoulsby]

Hi, can I check a couple of things:
1) power is on to module before and during upload
2) black wire of ftdi is facing down
3) successfully installed ftdi drivers (on downloads page)
4) if yes to above try a restart of Mac. Sometimes needed to fully install ftdi.