Messages

https://soundcloud.com/modman/pauls-song

Here's a song I made using the mAM as a thank you to you!

Dude.....Idk if you're gonna laugh or cry....But i assumed that jumper needed to be there.....so I put it there...I just removed it and everything works fine now......Holy shit i'm sorry for wasting your time lol.

Ran all those test, Everything is how it should be. I think it could be software/programming maybe? The buttons read out about 11ohms unpressed and .04 ohms pressed and that sounds right to me so idk what could be going on.

My buddy has an arduino uno at work I can try, but that won't be till Tuesday, If that fails I can also rework the pins again and make sure they're 100%. Real bummer this is happening :/. Thanks for all the help!

Double checked all of them, they're all correct. Yeah i tested it using the bare pins. This is strange, everything else is working 100% (Beside the filter cutoff being a bit noise at the beginning) it's only this one thing.

Okay, so pin 7 is shorting with pins 6,5, and 1. However the resistance between them is about 15 ohms, so are those suppose to be connected?

Not home so I don't have a MM handy. Visually, the pins don't appear to have a short. To be clear D12 & 13 are pins 5 & 6 on CONN2 correct?

Here's pictures of the board (Don't mind the flux, haven't gotten around to cleaning it yet)

http://imgur.com/GvSN9Tb,umPwoEh,TyBLNha,4635zAV,ucZPqBZ#0

Video of the problem: https://vid.me/P0SB