Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - modman

Pages: [1]
1
miniAtmegatron Hardware technical support / Re: Function not working
« on: September 08, 2015, 12:07:07 AM »
https://soundcloud.com/modman/pauls-song

Here's a song I made using the mAM as a thank you to you!

2
miniAtmegatron Hardware technical support / Re: Function not working
« on: September 07, 2015, 07:42:19 PM »
Dude.....Idk if you're gonna laugh or cry....But i assumed that jumper needed to be there.....so I put it there...I just removed it and everything works fine now......Holy shit i'm sorry for wasting your time lol.

3
miniAtmegatron Hardware technical support / Re: Function not working
« on: September 06, 2015, 11:08:40 PM »
Ran all those test, Everything is how it should be. I think it could be software/programming maybe? The buttons read out about 11ohms unpressed and .04 ohms pressed and that sounds right to me so idk what could be going on.

4
miniAtmegatron Hardware technical support / Re: Function not working
« on: September 05, 2015, 10:13:37 PM »
My buddy has an arduino uno at work I can try, but that won't be till Tuesday, If that fails I can also rework the pins again and make sure they're 100%. Real bummer this is happening :/. Thanks for all the help!

5
miniAtmegatron Hardware technical support / Re: Function not working
« on: September 05, 2015, 07:24:17 PM »
Double checked all of them, they're all correct. Yeah i tested it using the bare pins. This is strange, everything else is working 100% (Beside the filter cutoff being a bit noise at the beginning) it's only this one thing.

6
miniAtmegatron Hardware technical support / Re: Function not working
« on: September 05, 2015, 04:52:55 PM »
Okay, so pin 7 is shorting with pins 6,5, and 1. However the resistance between them is about 15 ohms, so are those suppose to be connected?

7
miniAtmegatron Hardware technical support / Re: Function not working
« on: September 05, 2015, 02:02:56 PM »
Not home so I don't have a MM handy. Visually, the pins don't appear to have a short. To be clear D12 & 13 are pins 5 & 6 on CONN2 correct?

8
miniAtmegatron Hardware technical support / Function not working
« on: September 05, 2015, 12:39:41 PM »
Here's pictures of the board (Don't mind the flux, haven't gotten around to cleaning it yet)

http://imgur.com/GvSN9Tb,umPwoEh,TyBLNha,4635zAV,ucZPqBZ#0

Video of the problem: https://vid.me/P0SB

Pages: [1]