News:

SMF - Just Installed!

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Neal Beard

#1
Many thanks for the reply.
I ended up using my wife's MacAir to load the firmware, which worked fine.
Next time I'll try with my MacPro and try a restart if it doesn't work.

Good luck with the ongoing development of the ATMULTITRON!
#2
Hello all, I'm trying to put a different engine on my Atmegatron but the Easy Uploader doesn't seem to recognise the cable ie it doesn't give it me as an option in the drop down.

I downloaded driver 2.4.2 and I'm running Mac OS 10.13.6

The Mac seems to see it as taken from the system check below...

Anyone any ideas? Thanks!
 
FT232R USB UART:
Product ID:   0x6001
  Vendor ID:   0x0403  (Future Technology Devices International Limited)
  Version:   6.00
  Serial Number:   AL01NSMA
  Speed:   Up to 12 Mb/sec
  Manufacturer:   FTDI
  Location ID:   0x14100000 / 18
  Current Available (mA):   500
  Current Required (mA):   90
  Extra Operating Current (mA):   0
#3
Atmegatron / Any more Atmegatrons?
November 09, 2017, 01:53:55 PM
Aghh! I couldn't get to Synthfest and so wondered if the remaining B stock has gone, or if the ATmegatron will do another production run?
Or does anyone have one they want to sell me?
Many thanks