News:

SMF - Just Installed!

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - klaus

#1
IT WORKS!
What I did:
1. cut the connections of Tx and Rx
2. went back to original firmware
3. tested midi via Tx and Rx (serial) > worked
4. reinstalled moco firmware
5. reinstalled miniAtmegatron firmware
6. tested it with Tracktion 6 > it works!

Maybe the solution was to not connect the UNO with the miniAtmegatron board thru Tx and RX.
#2
Yes DAW is at channel 1. I use the original Arduino Uno and the MacBookPro recognizes the midi device (MIDI/MOCO for LUFA) but there is no traffic either way. I also checked it on another Mac and with another cable with no success.
And yes, it works great through the internal audio out connected to my amp.
Maybe I should try to redo the Midi Hack. I'm a bit lost now...
#3
Hi, I am new to arduino and the miniAtmegatron.
While I succeeded to assemble the board - even the LEDs - and implemented the midi hack, I am not able to get my macbook and the miniAtmegatron to exchange midi signals. The MB sees the midi over USB connected arduino as MIDI/MOCO for LUFA but there is no exchange of notes. I use MidiPipe to test it.

Have I forgotten to initialize anything?

Thanks,
Klaus