Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - mharpum

Pages: [1]
1
Software technical support / lemon goodness
« on: April 01, 2015, 05:50:24 PM »
Hello again! Gotta say I am a big fan of adventure time and this lemongrab version looks amazing!

I have just tried to upload it, arduino is telling me the sketch is too big!

Binary sketch size: 32,714 bytes (of a 32,256 byte maximum)
processing.app.debug.RunnerException: Sketch too big; see http://www.arduino.cc/en/Guide/Troubleshooting#size for tips on reducing it.
   at processing.app.Sketch.size(Sketch.java:1658)
   at processing.app.Sketch.build(Sketch.java:1591)
   at processing.app.Sketch.exportApplet(Sketch.java:1613)
   at processing.app.Sketch.exportApplet(Sketch.java:1599)
   at processing.app.Editor$DefaultExportHandler.run(Editor.java:2380)
   at java.lang.Thread.run(Thread.java:619)

Please can you help?

I need lemon goodness in my life! I will make you a song with it if you can:)

Mark

2
Hello, sorry to be such an arduino noob. I'm loving the atmegatron so thought I would have a go at uploading the atcylotron, I have followed your install video and done everything up to the point of uploading the software to the device and I get this error message in arduino software:


Arduino: 1.6.0 (Windows 8), Board: "Arduino Uno"

Hardware.ino:19:75: fatal error: MCP23S17.h: No such file or directory
compilation terminated.
Error compiling.

  This report would have more information with
  "Show verbose output during compilation"
  enabled in File > Preferences.


I get this one in the previous version of arduino:

Arduino: 1.5.8 (Windows 8), Board: "Arduino Uno"

Hardware.ino:19:75: fatal error: MCP23S17.h: No such file or directory
compilation terminated.
Error compiling.

  This report would have more information with
  "Show verbose output during compilation"
  enabled in File > Preferences.


Any help would be much appreciated!

Thanks.

3
Software technical support / Use Atmegatron as an effects module?
« on: February 13, 2015, 05:38:34 PM »
I am wondering if it would be possible to set up the atmegatron as an effects module.  Do you have the capability to re route the headphone output to be used as an input? Then use the jack for output or vica versa? Just thinking this would be awesome if you could use it as a bit crusher/filter/reverb/delay/whatever other effect you can cram in there module.

Thanks,

Mark.

Pages: [1]