Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - gr33n

Pages: [1]
1
I have the Atmegatron Odytron SE that suddenly won't power up. I was uploading some different software and then it seemed to lose power/lights out.

I had successfully re-installed the Odytron v1.3 software. I think I have accidentally uploaded the Odytron patches (Ody Factory.eep.hex) as software rather than via the 'load patches' option(!) - could this have messed things up?

I haven't had any problems before and am using the supplied cable, etc. but it's been a while since I uploaded different software so am worried that I might have not followed the proper procedure. Any ideas would be gratefully received! Thank you.

2
I tried uploading software including Acyclotron, etc which didn't seem to work. This resulted in no lights or sound from the unit. I have just tried loading the Atmegatron v2.5 to rectify but still no lights/success. Any help appreciated!

"/Volumes/EasyUploader/EasyUploader.app/Contents/MacOS//avrdude" -c arduino -p m328p -C "/Volumes/EasyUploader/EasyUploader.app/Contents/MacOS/avrdude.conf" -P /dev/cu.usbserial-AL01NT5Y -U flash:w:"/Volumes/HD 2 Music/x Atmegatron/AtmegatronV2-5.hex":i
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x00

avrdude done.  Thank you.

Pages: [1]