Hello all, I'm trying to put a different engine on my Atmegatron but the Easy Uploader doesn't seem to recognise the cable ie it doesn't give it me as an option in the drop down.
I downloaded driver 2.4.2 and I'm running Mac OS 10.13.6
The Mac seems to see it as taken from the system check below...
Anyone any ideas? Thanks!
FT232R USB UART:
Product ID: 0x6001
Vendor ID: 0x0403 (Future Technology Devices International Limited)
Version: 6.00
Serial Number: AL01NSMA
Speed: Up to 12 Mb/sec
Manufacturer: FTDI
Location ID: 0x14100000 / 18
Current Available (mA): 500
Current Required (mA): 90
Extra Operating Current (mA): 0
Hmm. This all seems correct. Have you tried a restart? Sometimes required on Macs.
To confirm: you're using an FTDI cable from the Atmegatron accessories pack? you got the driver from here? https://www.ftdichip.com/Drivers/VCP.htm (https://www.ftdichip.com/Drivers/VCP.htm)
Many thanks for the reply.
I ended up using my wife's MacAir to load the firmware, which worked fine.
Next time I'll try with my MacPro and try a restart if it doesn't work.
Good luck with the ongoing development of the ATMULTITRON!