News:

SMF - Just Installed!

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Glowtide

#1
*Edit* Apparently it was Microsoft edge downloading the files I some strange format. Tried it on chrome and now everything works perfectly again strings and all!
#2
"C:/Program Files (x86)/Soulsby Synthesizers/EasyUploader//avrdude" -c arduino -p m328p -C "C:/Program Files (x86)/Soulsby Synthesizers/EasyUploader/avrdude.conf" -P \\.\COM3 -U flash:w:"C:/Users/contr/Downloads/Atmegatron1.hex":i

avrdude: AVR device initialized and ready to accept instructions

Reading | ################################################## | 100% 0.02s

avrdude: Device signature = 0x1e950f
avrdude: NOTE: FLASH memory has been specified, an erase cycle will be performed
         To disable this feature, specify the -D option.
avrdude: erasing chip
avrdude: reading input file "C:/Users/contr/Downloads/Atmegatron1.hex"
avrdude: WARNING: no end of file record found for Intel Hex file "C:/Users/contr/Downloads/Atmegatron1.hex"
avrdude: writing flash (28576 bytes):

Writing | ################################################## | 100% 0.37s

avrdude: 28576 bytes of flash written
avrdude: verifying flash memory against C:/Users/contr/Downloads/Atmegatron1.hex:
avrdude: load data flash data from input file C:/Users/contr/Downloads/Atmegatron1.hex:
avrdude: WARNING: no end of file record found for Intel Hex file "C:/Users/contr/Downloads/Atmegatron1.hex"
avrdude: input file C:/Users/contr/Downloads/Atmegatron1.hex contains 28576 bytes
avrdude: reading on-chip flash data:

Reading | ################################################## | 100% 9.61s

avrdude: verifying ...
avrdude: verification error, first mismatch at byte 0x0080
         0xff != 0x31
avrdude: verification error; content mismatch

avrdude done.  Thank you.


I tried uploading the strings software at first which didn't seem to work. I turned the programmer switch off and took the cable out and de powered the unit. Now when I plug the power cable in nothing lights up. I tried uploading the default software and that doesn't seem to work either.