Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - CatizenSnaps

Pages: [1]
1
miniAtmegatron / Build problems. Fried board?
« on: July 03, 2018, 12:53:43 AM »
Hello folks,

I recently sat down and put together a mini-Atmegatron kit and, upon completion, have found that it's completely functionless, won't power up at all. During the build, I had to desolder and refit one capacitor, and I fear I may have overheated and fried the board in the process - the metal circuit bit on the PCB peeled off slightly and I had a tough time getting the solder to stick again. I also had a little difficulty soldering the LEDs and I think I've bridged the three pins on one of them - I have a yet to correct this as I'm a little wary of desoldering following the prior problem. Is there anything I can do to try to fix it or is it likely that the board is irreparably damaged? If so, is there any way that I can purchase just a new board without the rest of the kit - the components and Arduino all seem fine. I've attached some pictures of the board for illustration. Still getting the hang of soldering and this is my first kit build, so please bear with me if this is more obvious than it seems. All feedback greatly appreciated!

Pages: [1]