Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - dcpnoise

Pages: [1]
1
Hey guys, ist there anything like a list of the selectable waveforms, filter types, Envelopes and the other parameters available in the miniATMEGATRON?

It's clear, that there are different parameters you can change one at a time by pushing the func button and then adjusting the parameter by pressing the value buttons. OK so far.

- But which and how many waveforms are actually included in the software? It's sometimes very hard to tell what waveform the current selected one should resemble (some square-ish lofi wave, hm, the next one sounds a bit like a sawtooth, etc. but what is it really called and meant to sound like, etc.?)  ???

- Or the filter types, it sometimes isn't clear even when you try the knobs Fc or Q what the filter actually should do, sometimes something happens, at the next setting the knobs don't change the sound at all and if they do in most cases it sounds like a noisy bitcrusher effect not anywhere near a 'real' low/band/highpass filter with some resonance. (yes, I did not forget to turn down Dist and Phase or at least try to shut off the wavecrusher  ;) )

- Or which envelope should do what, how's the env-shape looking like, which one does support sustain and which doesn't.

- And last but not least the Wavecrusher/Portamento settings, what is which parameter meant to represent, starting from 0 to max? I just can't figure out on what setting the wavecrusher or portamento are completely shut off.  :-[

A list of available settings (like for example: Waveforms -> Square, Saw, Sine, x, y, z, and so on. Or Filters -> Lowpass with Q, Lowpass without Q, Bandpass, Higpass, Noise, whatever else...) would help very much to understand that little critter a bit better.  :)

I hope someone (Paul? Nudge, nudge  ;) ) can help me out.

Pages: [1]